Lucie Playford

Subaru Impreza Key Problems

Subaru Impreza keys allow owners to lock and unlock their vehicle by pressing the button. The most frequent reason for the key fob to stop working is a dead battery in the key fob.

It is simple to change the battery. First find the small device with the flat circular battery in the key encasement. Replace the battery by opening the unit and ensuring that the correct side of the battery is facing upwards.

Keys stolen or lost

We've all experienced it when you reach into your pocket to find the keys, but they are nowhere to be seen. Fortunately, it's not too hard to find your Subaru keys and there are many ways to replace them quickly and inexpensively.

If you already have a standard metal car key, you can get it duplicated at a hardware store that stocks Subaru blanks. They are typically marked "Subaru". If they want to replace batteries in the key fob, they can buy a CR-2032 at many hardware stores or online retailers like Amazon.

You'll need to visit an Subaru dealer or a locksmith for your car to program new keys. This will cost you between $50 to $250, based on whether your Subaru features a transponder chip or smart key feature.

You'll need to supply the locksmith or dealer with your vehicle identification number (VIN) located on the dashboard, just below the windshield. They'll require this number to verify the car is in warranty and that the new key is coded to match the specific model and year of your Subaru. The VIN contains details about the manufacturer and the place where the car was manufactured. It also tells you if there are any special features on the car like immobilizers that prevent the engine starting when a key that is not correct is used.

Faulty Key Fob

A key fob that does not perform as it should can be caused by a number of factors. It could be a simple problem with the battery or it could require a more complicated repair. A dead battery, programming issue in the car or electrical issues with the vehicle are just a few of the most frequent issues with a Subaru keyfob.

One of the easiest fixes is to replace the battery of the key fob. They can be found in a variety of big-box retailers as well as hardware stores. They cost about $10 per and can be replaced in a few minutes. how to replace subaru key fob to do this is in the owner's manual. There are many YouTube videos that walk you through the process.

Damage to the key fob is a different possible cause. The clips made of metal that hold the batteries could be damaged if remove it from your pocket and then get it wet. If the key fob still isn't working after replacing the batteries, it could be related to the transmitter or with other components of the vehicle. A technician trained in troubleshooting the vehicle will determine the cause and pinpoint the issue. They can reprogram the key fob and make sure that it works with the vehicle. They can also examine for any wiring or antenna issues which could stop the key fob from sending signals properly.

Unlocking or locking issues

There are a few possibilities for the Subaru Impreza's ignition key not locking or unlocking the doors. This problem can be caused by a dead coin battery, a malfunctioning module and signal interference or water damage. To resolve this issue, you can go to an authorized locksmith or a dealer to have the key fob reprogrammed.

If you're unable to open the trunk, it is likely that the trunk lock setting on the key fob is set to "on". This is a security measure that helps prevent thieves from stealing the vehicle. Contact your subaru key fob replacement near me dealership to change the trunk lock/unlock settings.

Another reason why you may have a locked steering wheel occurs when you make a sudden turn and the car locks itself automatically. This happens when the vehicle detects a fast turn, which could impact its transmission system as well as the engine. Make sure to slow down when turning to avoid this.

Make sure you verify that the replacement key fob subaru keys or spare subaru key key that you have was cut and programmed by the locksmith or dealer. Make sure that the emergency key can be able to work on the trunk and all door cylinders as it is the only means to get back into your vehicle in the event that you are locked out. Also, make sure that the new key or spare doesn't have any marks or scratches, or evidence of manipulation on it.

Keyless Entry

Many Subaru models are equipped with keyless entry. This lets you lock or unlock the doors and trunk by pressing a button on the remote. The system uses radio signals to connect with the vehicle when you are within range. There are a number of different systems on the market that offer this functionality starting with simple kits that unlock just the door for the driver, to more advanced ones which also permit remote starting and smartphone integration.

The convenience of keyless entry on your Subaru is convenient and safe but it's vital to be aware of what to do if the buttons stop working properly. You can try troubleshooting yourself, however it may be essential to have your Subaru evaluated by an expert. Use these suggestions to keep your remote functioning just as it should.

If the fob of the key for your Subaru is soaked, you should clean it with isopropyl, then let it completely dry before installing the battery. Regularly cleaning it will stop moisture from damaging the fob and causing further issues down the road.

If your key fob isn't responding, you can switch off the engine by opening the door on the driver's side. Press the door button one time to unlock it, and after that, press it again to close. You will need to press the button a handful of times, usually one for each digit until you hear the sound. Then, repeat the procedure with each door until receive a response from each of them.